Cuberite Forum › Cuberite › Discussion
Command in Rev. 236 not work

Linear Mode
Command in Rev. 236 not work
NiLSPACE Offline
Cuberite Developer
******
Posts: 4,628
Threads: 115
Joined: Dec 2011
Thanks: 693
Given 494 thank(s) in 423 post(s)
#5
02-26-2012, 12:33 AM
MCServer has one command by default. /coords
Find
Reply
Thanks given by:


Messages In This Thread
Command in Rev. 236 not work - by stanik - 02-24-2012, 10:48 AM
RE: Command in Rev. 236 not work - by FakeTruth - 02-25-2012, 03:33 AM
RE: Command in Rev. 236 not work - by stanik - 02-25-2012, 11:30 PM
RE: Command in Rev. 236 not work - by FakeTruth - 02-26-2012, 12:26 AM
RE: Command in Rev. 236 not work - by NiLSPACE - 02-26-2012, 12:33 AM
RE: Command in Rev. 236 not work - by FakeTruth - 02-26-2012, 01:25 AM



Users browsing this thread: 1 Guest(s)