Cuberite Forum › Cuberite › Discussion
how do i use identifiers?

Linear Mode
how do i use identifiers?
NiLSPACE Offline
Cuberite Developer
******
Posts: 4,633
Threads: 115
Joined: Dec 2011
Thanks: 694
Given 494 thank(s) in 423 post(s)
#2
12-23-2024, 08:06 PM
Unfortunately command blocks are barely supported by Cuberite. They currently use the same command handlers as console commands. Because of this target selectors aren't supported as of yet.
Find
Reply
Thanks given by:


Messages In This Thread
how do i use identifiers? - by froggotheadmin - 12-23-2024, 04:12 PM
RE: how do i use identifiers? - by NiLSPACE - 12-23-2024, 08:06 PM
RE: how do i use identifiers? - by froggotheadmin - 12-23-2024, 08:52 PM
RE: how do i use identifiers? - by NiLSPACE - 12-23-2024, 09:03 PM



Users browsing this thread: 2 Guest(s)