Cuberite Forum › Plugins › Plugin Requests
Protection areas

Linear Mode
Protection areas
Seemonster Offline
Junior Member
**
Posts: 12
Threads: 3
Joined: Dec 2023
Thanks: 0
Given 0 thank(s) in 0 post(s)
#3
12-24-2023, 11:38 AM
Yes i did, the actual command is /protection wand , but when i set coords, it didnt set them properly
Find
Reply
Thanks given by:


Messages In This Thread
Protection areas - by Seemonster - 12-24-2023, 04:13 AM
RE: Protection areas - by NiLSPACE - 12-24-2023, 04:24 AM
RE: Protection areas - by Seemonster - 12-24-2023, 11:38 AM
RE: Protection areas - by NiLSPACE - 12-24-2023, 08:18 PM
RE: Protection areas - by Seemonster - 12-25-2023, 12:07 AM
RE: Protection areas - by Seemonster - 12-25-2023, 02:06 AM
RE: Protection areas - by NiLSPACE - 12-25-2023, 02:38 AM
RE: Protection areas - by Seemonster - 12-25-2023, 03:41 AM
RE: Protection areas - by Seemonster - 12-25-2023, 04:06 AM



Users browsing this thread: 1 Guest(s)