Compiling for powerpc (Darwin 9/OS X 10.5)
#2
Apparently when a program compiles and runs fine under Linux it is not guaranteed to compile and/or run on a Mac.

There have been a lot of changes since the last time a stable release was made for Mac so it's most likely broken Sad

XCode is an IDE right? Could you try attaching the debugger to MCServer to see where it crashes/segfaults/bus errors?
Reply
Thanks given by:


Messages In This Thread
RE: Compiling for powerpc (Darwin 9/OS X 10.5) - by FakeTruth - 03-09-2012, 11:12 AM



Users browsing this thread: 2 Guest(s)